Although the commands are the same as the ML520/521, the measurements specified by the parameters are different, so a separate chapter was included to avoid confusion. This chapter describes the commands for setting up and printing bar codes using the MICROLINE Models 590 and 591 printers. Note: MICROLINE Models 320 and 321 do not have the bar code commands. This chapter describes the commands for setting up and printing bar codes using the MICROLINE Models 520 and 521 printers. This chapter explains the commands used to move the printhead up and down on the page, including the commands for setting the top and bottom margins (Top of Form and Page Length commands), the Form Feed command, the Line Feed commands (forward and reverse), the Line Spacing commands, the Skip Over Perforation commands, and the commands for setting vertical tabs. This chapter explains the commands used to move the printhead back and forth, including the Backspace and Carriage Return commands, as well as commands for setting the left and right margins, commands for setting indents and horizontal tabs, commands for setting the type of justification, and the Uni-directional Print commands for optimum registration when printing graphics. This chapter discusses the graphics commands which permit you to design and print your own graphic images using single, double, or quadruple density graphics. It also explains the commands to copy the characters from ROM to RAM and to download custom characters.
OKIDATA MICROLINE 320 TURBO MANUAL HOW TO
This chapter illustrates how to design custom characters. This chapter describes the commands for selecting the character style: including the print mode to be used (High Speed Draft, Utility, Near Letter Quality), the font to be used (IBM only), emphasized and/or enhanced printing, italics, underline, and overscore (IBM only). It also explains the Combined Print Features command and the Intercharacter Spacing commands. This chapter explains the commands for selecting pitch (characters per inch - cpi) or proportional printing, for switching to superscript or subscript characters, and for engaging double height and/or width. This chapter describes the commands for selecting special character sets.Ĭhapter 3: Character Size/Spacing Commands This chapter provides information on selecting printer drivers. It contains additional information on working with software packages and on the printer commands, as well as interfacing specifications.Ĭhapter 1: Working with Commercial Software
OKIDATA MICROLINE 320 TURBO MANUAL MANUAL
This Programmers Guide/Reference Manual is a supplement to the MICROLINE 320/321, 520/521, and 590/591 Printer Handbooks.